#Fsuipc fsx serial serial number
#Fsuipc fsx serial software

grГјn - at least one supported module has been recognized on your PC.

gelb - No supported module has been found.

Modules - shows the status of currently connected modules.

You can also open the Config-Wizard by double clicking on the row. Click on the button to access the Config-Wizard (see. This value can vary from the original FSUIPC value according to the rules you configure in the Config Wizard. Output Value - Current value which is used for the output device.

#Fsuipc fsx serial software

Only up-to-date if the software is connected to the flight sim and running (Run Mode). FSUIPC Value - Current FSUIPC value which has been read by the software.It helps for orientation and can be helpful for sorting the rows when using various modules.

#Fsuipc fsx serial serial number

Module Serial - The serial number or the name of the used module.It helps for orientation and can be helpful for sorting the rows. FSUIPC Offset - It shows the used FSUIPC offset.Double click on the field in the desired row to activate edit mode. Description - You can assign a meaningful name for each config item.Also during Test Mode only the active items are considered. Only active items are updated with FSUIPC values when running the software. Active - the config item is activated.The config list items contain the following information: The configuration list on the output tab shows you all entries of the currently loaded file (see file name in title bar). Hint: If there are still unsaved changes, you will see a message that informs you and gives you the possibility to first save your changes or discard them - as you like. This makes it easy to be started by FSUIPC on automatically during start up of your flight sim. The order of start (MFConnector and flight sim) does not matter. The application minimizes to the taskbar and it waits until the connection to your flight sim becomes available. AutoRun - Can be activated and then runs MF Connector automatically on next start using the last loaded Configuration (Run-Mode).Stop - Stops the currently active mode (Run/Test).It helps most with LEDs and 7 segment displays With this function you can check that your configuration is addressing the correct output device. For each configuration item the test mode is toggled. It is only clickable if supported modules are recognized (MobiFlight Board or Arcaze) and your flight sim is running Run - executes the current configuration.It is enabled if there are changes made to the current configuration. Save - save the current configuration.